uniphy PHYACTION 190, Информация о сервисе

Страница: 40 / 46

10) Ensure the treatment head to be dry and
clean, then turn up the intensity knob. The
Phyaction 190 will now tune the treatment
head. The Phyaction 190 will show figure 7
during tuning.
11) When you see the screen as in figure 8, turn
back the intensity knob to its zero position.
12) Put the selected treatment head in a large
bowl amply filled with water (about 18°C).
Keep the treatment head in such a way that
the generated ultrasound cannot reflect onto
the treatment head.
13) Now turn up the intensity knob (see figure 9).
The Phyaction will now tune the treatment
head. The Phyaction 190 will show figure 10
and 11 during tuning. The Phyaction will
show if the tuning has succeeded. It shows
the frequency at which it is tuning the head,
followed by the message 'Done' or 'Bad'.
14) If one or two of the results are 'Bad', the
tuning has not succeeded. A code
representing the reason why the tuning has
not succeeded, occurs in the lower right
corner (see figure 12). Turn back the
intensity knob to its zero position. Now wait
until the service menu appears again.
Repeat the steps from step 7 (including
checking of the head parameters).
When the result is still bad, contact your
supplier.
15) When the treatment head is tuned on both
frequencies (see figure 13), turn back the
intensity knob to its zero position. Now wait
until the service menu appears again.
16) Now you have tuned the treatment head to
the Phyaction 190.
17) If you want to tune another treatment head,
continue with step 7 and choose the other
treatment head
18) Turn off the Phyaction 190 (but remember,
not before the service menu has appeared)
19) Turn on the Phyaction 190 and check the
contact control of the head(s) you have just
tuned (see the Instructions for use).
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13