Union Audio Orbit.6, Руководство пользователя

Страница: 16 / 28

16
Orbit 6’ s Master and Booth Output XLR connectors are located on the left - hand side of
the rear panel. There is also a pair of Mix Insert patch points for connection to external
audio processors (compressors, limiters, graphic EQ etc).
Master Out – The Master Output XLRs are electronically balanced, with Pin 2 hot
(positive phase), Pin 3 cold (negative phase), and Pin 1 ground. When the Master Level
control is fully clockwise, with the Meters reading –
4 VU the output level is
approxi6dBu.
Important please read!
The Master Out XLRs must only be used on equipment fitted with fully balanced
inputs. Never unbalance these outputs by connecting Pin 3 to ground, or use an XLR
to RCA type adaptor. For unbalanced operation connect only to Pin 2 and Ground and
leave Pin 3 floating.
Booth Out – The Booth Output XLRs are electronically “ EBOS ” balanced, with Pin 2 hot
(positive phase), Pin 3 cold (negative phase), and Pin 1 Ground. When the Master Level
control is fully clockwise, with the Meters reading –
4 VU the output level is
approximately +6dBu. These XLR outputs can be used balanced or unbalanced by
connecting Pin 3 to Ground.
Master Insert – The Master Inserts are fitted with 1/4” TRS Jacks and follow the
standard convention of Tip = Send, Ring = Return, and Sleeve the common Ground.
The connector
’ s normalising contacts by - pass the insert when nothing is plugged in.
Any External Processor should have a nominal operating level between – 2 dBu to
+18dBu. Be aware that any external equipment plugged into these sockets will have
an impact on audio fidelity, and we strongly recommend using only studio grade
equipment.
Mixer Output Connections
NOTE Both the Master and
Booth Outputs have auto -
muting to prevent clicks and
thumps in any connected PA
when powering the mixer on
or off.
Power On muting lasts
approximately 12 seconds,
Power Off muting is
instantaneous.