2 (+)
1 (-)
3
1.
Insert the earth cable plug into the required polarity and tighten - negative (-) for gas shielded wires wires.
2.
The weld power cable goes into the opposing positive (+) socket.
3.
Connect Gas Line to Gas Regulator and connect the gas regulator to the Gas Cylinder.
(4)
Fit the correct type and size of drive rollers. V
Groove for Hard Wires. Knurled for Flux Cored.
(5)
Place wire onto spool holder - (spool retaining nut is
left hand thread ) Feed the wire through the inlet guide
tube into the drive roller.
NOTE:
VIPER MIG 120 is not
suitable to weld Aluminium as it is a Synergic Welding
Machine programmed for Solid Mild Steel wire and
Flux Cored (Gasless) wires only.
(6)
Feed wire over the drive roller into the outlet guide
tube, Push the wire through approx 150mm.
VIPER 120 SYNERGIC MIG Welder |
11
MIG WITH GAS INSTALLATION
