Unimig RazorCut 45 KUPJRRW45, Руководство по эксплуатации

Страница: 10 / 24

10
(1) Connect the SC80 Plasma Torch to the machine. Insert the torch connection into the torch connection
receptacle at the front of the machine and screw up hand tight.
Caution: Be careful not to bend the pins located inside the torch connector.
(2) Connect the earth lead to the output terminal of the machine and tighten.
(3) Connect the machine to the correct power supply and switch on the machine using the on/off switch
located at the rear of the machine.
(4) Connect the air supply to the air connection located at the rear of the machine.
Turn on the air supply.
Set Up Procedure for PLASMA Cutting
1
2
(1) Connect the SC80 Plasma Torch to the machine. Insert the torch
connection into the torch connection receptacle at the front of the
machine and screw up hand tight.
Caution: Do not to bend the pins located inside the torch connector.
(4) Connect the machine to the
correct power supply and switch
on the machine using the on/off
switch located at the rear of the
machine..
(3) Connect the air supply to the
air connection located at the rear
of the machine. Turn on the air
supply.
(5) Set the air pressure select
switch to the down position to test
there is air flow through the torch.
(2) Connect the earth lead to the output terminal of the machine and
tighten.
(6) Return the air pressure select
switch to the ON position to set the
machine in ready to use mode.
The air requirement for torch SC80 is:
· Clean and dry compressed air
· Pressure for torch: 4.5~5.0bar, 65~75 psi
· Gas flow 110lpm