12
(7) Place wire onto spool holder - (spool retaining
nut is left hand thread ) Feed the wire through the
inlet guide tube on to the drive roller.
(3) Connect weld power lead to
(8) Feed wire over the drive roller into
the outlet guide tube, Push the wire
through approx 150mm.
(2) Connect earth lead
to
(5) Set torch operation 2T / 4T
(4) Set MIG/TIG/MMA selector
switch to MIG
IMPORTANT :
When connecting the torch
be sure to tighten the connection.
(1) Connect MIG torch
(5) Select torch operation 2T or 4T
Installation set up for MIG with Gas for RAZOR 205 MTS
(1) Connect Mig Torch
IMPORTANT :
When connecting the torch be sure to tighten the connection.
(2) Connect the earth lead to Negative socket
(3) Connect the weld power lead to Positive socket
(4) Turn the power source on and select the MIG function with the MIG/TIG/MMA selector switch.
(5) Set torch operation 2T / 4T.
• When 2T operation is selected press trigger Arc starts, release trigger, Arc stops.
burnback operation is automatic and preset.
• When 4T operation is selected press and release trigger Arc starts, press and release trigger Arc stops.
burnback operation is automatic and preset.
(6) Connect Gas Line to Gas Regulator and connect the gas regulator to the Gas Cylinder.
(6) Connect the gas line to the regulator
and connect to the gas cylinder
WARNING:
Disconnect the Electrode Holder cable from the machine before using MIG function. If cable is not disconnected welding
voltage is present and can cause arcing or flash.
WARNING:
Ensure that an approved welding helmet, protective clothing and gloves are use for all welding operations
Содержание KUMJRRW205MIG
Страница 50: ...50 Notes ...
Страница 51: ...51 Notes ...