6
1. Switch off the machine and make sure that no one may incidentally switch the it on.
2. Place the required tool inside the chuck and tighten it securely. Close the chuck cover.
3. On the work piece mark the position for the opening or grove. Securely tighten the work piece on the work
table.
4. Using the setting wheel, lift the object to required height.
5. Turn on the switch.
6. When creating the grove move the table back and forward and across. You may adjust the cross feed and
the forward or backward motion of the platform by stopping shaft under the table.
•
Leave the pump stopped for one hour to allow the oil to settle down before bleeding.
•
NOTE:
if you don't give the oil enough time to settle down, air may be still present in the oil. The pump will
not be bled sufficiently for the first time and you will have to repeat the bleeding process.
•
You will bleed the hydraulic system thoroughly if you press the releasing pedal (10) and press the lifting
pedal (7) ten to fifteen times.
•
Test-lift the platform without any load. Lift the platform all the way up and lower it down. The lowering speed
may be controlled by pressing the releasing pedal (10).
OPERATION
BEFORE FIRST USE
WARNING!
Before first use, read all safety instructions carefully. Make sure you understand all instructions.
WARNING!
Do not overload the jack.
•
Install the jack on solid and levelled floor, capable of supporting its weight (e.g. concrete floor).
•
Manoeuvre the motorcycle on the platform through the access ramp.
NOTE:
different sizes of vises may be mounted on the platform to hold different sizes of motorcycles.
•
Lock the front motorcycle wheel in the vise jaws to secure it in place.
•
Also fasten the motorcycle to the platform by fastening belts.
•
Step repeatedly on the lifting pedal (7) and lift the platform.
•
When the platform reaches the required height, push the safety bar (48) through one of the holes in the
platform to prevent incidental fall or movement.
•
When you finish you work, make sure the space below the platform is clear, so you can safely lower the
platform down. Remove the safety bar and SLOWLY press the releasing pedal (10). Lower the platform
SLOWLY.
NOTE:
the lowering speed is controlled by release valve. The more is the valve open, the faster the platform
goes down. Make sure you lower the platform carefully and slowly.
•
When the platform reaches the floor, remove the fastening belts, open the vise jaws and steer the
motorcycle out of the platform.
OPERATION INSTRUCTIONS
7
