Pneumatic Floor Nailer / Stapler
E&OE
© 2017 Unimac
3
General Electrical Safety
•
Inspect electrical equipment, extension
cords, power bars, and electrical fittings
for damage or wear before each use.
Repair or replace damaged equipment
immediately.
•
Ensure all power sources conform to
equipment voltage requirements and
are disconnected before connecting or
disconnecting equipment.
•
When wiring electrically powered
equipment, follow all electrical and
safety codes.
•
Wherever possible, use a residual
current device (RCD).
•
High voltage / high current power lines
may be present. Use extreme caution
to avoid contact or interference with
power lines. Electrical shock can be
fatal.
General Electrical Safety
•
Electrically grounded equipment must
have an approved cord and plug and be
connected to a grounded electrical
outlet.
•
Do NOT bypass the ON/OFF switch
and operate equipment by connecting
and disconnecting the electrical cord.
•
Do NOT use equipment that has
exposed wiring, damaged switches,
covers or guards.
•
Do NOT use electrical equipment in wet
conditions or in damp locations.
•
Do NOT use electrical cords to lift,
move or carry equipment.
•
Do NOT coil or knot electrical cords,
and ensure electrical cords are not trip
hazards.
General Service Information
•
The equipment must be serviced or
repaired at authorised service centres
by qualified personnel only.
•
Replacement parts must be original
equipment manufacturer (OEM) to
ensure equipment safety is maintained.
•
Do NOT attempt any maintenance or
repair work not described in this
manual.
•
After use, the equipment and
components may still be hot
– allow the
equipment to cool and disconnect
spark plugs and/or electrical power
sources and/or batteries from it before
making adjustments, changing
accessories or performing repair or
maintenance.
•
Do NOT make adjustments while the
equipment is running.
•
Perform service related activities in
suitable conditions, such as a
workshop.
•
Replace worn, damaged or missing
warning/safety labels immediately.
