Unimac NAL-FLOOR, Руководство пользователя

Страница: 9 / 13

100psi Pneumatic 2 in 1 Nailer
E&OE © 2017 Unimac 8
Maintenance
Clean and Inspect Daily
CAUTION
: Disconnect tool from air supply before cleaning and inspection. Correct all problems before putting the
tool back into use.
Wipe tool clean and inspect for wear or damage. Use non-flammable cleaning solutions to wipe exterior of tool
only if necessary.
DO NOT SOAK
tool with cleaning solutions. Such solutions can damage internal parts.
Inspect mechanism to assure that the system is complete and functional; no loose or missing parts, no binding
or sticking parts.
Keep all screws tight. Loose screws can cause personal injury and can damage tool.
If tool is used without an in-line oiler, place 10 or 15 drops of Air Tool Oil into the air inlet of the tool at the
beginning of each workday.
IMPORTANT
: Do not over-lubricate the nailer. Excess oil mist or drops will be vented with spent air when over-
lubricated. Excess oil could stain materials. Purge excess oil first before you begin nailing.
Service and Repairs
All quality tools eventually require servicing of replacement of parts due to wear from normal use. Some user
serviceable components are described In the
Troubleshooting Section. All repairs must be done by a qualified
person or service centre.
Troubleshooting
CAUTION
: Disconnect tool from the air supply first before performing any troubleshooting procedures.
Problems Causes Possible Solutions
Air is leaking near the top
of the tool.  Loose screws.

Worn or damaged O-rings/seals.
 Tighten the screws.

Install the “OVERHAUL”
Maintenance Kit.
Tool does nothing or is
operating sluggishly.

Inadequate air supply.
 Inadequate lubrication.

Worn or damaged O-ring/seals.

Verify that there is adequate air
supply.

Put 10 to 15 drops of oil into the
air inlet.

Install “DRIVER” Maintenance
Kit.
 Install “OVERHAUL”
Maintenance Kit.
Air is leaking near the
bottom of the tool.  Loose screws.

Worn or damaged O-rings or
bumper.
 Tighten screws.

Install “OVERHAUL”
Maintenance Kit.
Tool is jamming frequently.

Incorrect fasteners.

Verify for approved fasteners of
correct size.