Multi-Function Sharpener – MFS2
E&OE
© 2017 Unimac
6
Inserting and Removing Sharpening Modules
The tool MUST be switched OFF and disconnected from the electrical supply when
attaching or removing sharpening modules. • It is recommended to fasten the tool to a
flat and stable surface, such as a bench. Use the 4 mounting holes for this and 5mm countersunk type
fasteners. • The retaining clip and sharpening modules are constructed from plastic – do not use excessive
force when inserting and removing sharpening modules.
The tool is equipped with three specialised sharpening modules for various sharpening tasks. The
sharpeners slide down over the grinding wheel and are held in position by guide slots in the tool body and
the retaining clip. The tool can "hold" all sharpeners as it has similar guide slots on each side. To insert a
sharpening module:
1. Align the mounting "rails" (
A
) on the edges of the sharpening module with the guide slots (
B
) in the tool
body on either side of the grinding wheel.
2. Slide the sharpening module down into the tool until it "clicks" into place. When correctly inserted, the
retaining clip will prevent the module from being removed [a small amount of vertical movement of the
module may be noticed if you pull it upward – this is normal].
To remove a sharpening module:
1. Press down on the retaining clip (
C
) just enough for it to disengage from the sharpening module and hold
it there.
2. Pull the sharpening module from the tool, then release the retaining clip.
A
B
B
