Unika PS-3000, Инструкция пользователя

Страница: 8 / 12

Setup Front Panel Rear Panel 
Stereo Operation

Mono Bridge Operation
Specifications
Operating Instructions
 Parallel Mono Operation
U S E R I N S T R U C T I O N S
page 7
CH.2
CH.1
CH.1
INPUT
Parallel Mono Operation
Follow these instructions for parallel Mono Operation using a single input cable, and you will have the same
monophonic signal on both the channel 1 and the channel 2 output.. Each channel's output is controlled
independently by that channel's level control.
1. With the power off, set the OPERATION MODE SWITCH
（
6
）
to the PARALLEL MONO position. When the power is on, the PARALLEL MONO LED
（
12
）
on the
front panel will light. If the LED does not illuminate, you have the switch in the wrong position. Correct before continuing.
2. With the power off, connect your input cables to channel 1 only using the either the female XLR INPUT JACK
（
11
）
or male XLR INPUT JACK
（
11
）
of channel 1.
The other channel 1 input can be used to link to an additional amplifier.
3. Connect the loudspeakers to the channel 1 and channel 2 SPEAKER OUTPUT
（
9
）
. THE TOTAL SPEAKER LOAD MUST BE AT LEAST 2 OHM PER CHANNEL. If
you try to operate a lower impedance, the amplifier will go into protection mode and stop operation until you correct the load conditions.
4. With the LEVEL CONTROLS
（
8
）
set to zero (fully counterclockwise), switch the power on. Apply a signal to the input. The level of the input signal should be as high
as you will ever need it to be. This way, it will be as high above the amplifier's noise floor as possible, ensuring an excellent performance and signal to noise ratio.
Adjust the LEVEL CONTROLS for each channel to achieve the desired maximum listening level.

NOTE : When the clip LEDs light, there is distortion present in the amplifier's output section. If a clip LED remains on or flashes repeatedly, reduce the signal level
by lowering the input level control for the channel that is clipping or reduce the level at the source.
PS-3000/PS-4000/PS-5000
UNiKA