Unika MT-1000, Инструкция пользователя

Страница: 6 / 12

INPUTS -
The MT-1000 and MT-2000II amplifiers allow you to use two types of input connectors per channel, a XLR female jack for balanced
connections and a 1/4” TRS female jack that will accept balanced and unbalanced connectors. Use these connections to connect the output
signal from a mixer, cross-over or EQ to the MT-1000 and MT-2000II amplifiers. A balanced connection is recommended for cable runs longer
than 20ft. When constructing your own XLR cables follow the pin configuration described below for proper connections. For cable runs shorter
than 20ft., you may choose the 1/4” TS unbalanced input option. The 1/4” TS unbalanced input option may be more convenient for most users
due to the abundant supply of prefabricated cables available at your local audio dealer. In addition, for the MT-2000II also has an option of
Euroblock input connectors for users to use.
BINDING POST/BANANA PLUG: Connect your speakers to the binding post outputs on the
rear of the amplifier. The speaker wire may be connected by bare wire (directly connected,
usually for permanent connections), banana plug, or spade connector. Connections are made
to channel one and channel two outputs for Stereo Mode or across the red terminals of channel
one and channel two for Mono Bridge Mode.
IMPORTANT NOTICE: Although a speaker will operate with the positive and negative leads
plugged into either terminal on the amplifier binding post, be sure to plug the negative lead into
the black terminal and positive lead into the red terminal. Ensuring proper polarity will avoid
speakers being out of phase that can cause a loss of bass response.
2 Hot (+data)
1
3
2
Male XLR Pin Configuration
Figure
5
1 Ground / Return / 0v
3 Negative (-data)
Balanced TRS 1/4” Plug
Hot (+)
Negative (-)
Ground/Shield
Figure
6
Unbalanced TS 1/4” Plug
Hot (+)
Negative (-)
Figure
7
page 5
SET UP
Important Precautions Introduction Front Panels Rear Panels Operating Modes Protection Features Specifications
Set Up
OUTPUTS -
UNiKA MT-1000/MT-2000II
Euroblock Input Connector
Figure 8
STEREO
AMP MODE
BRIDGE
CH 2 CH 1
_ _
+ +
Cold
Hot Ground