Unika MT-1000, Инструкция пользователя

Страница: 4 / 12

MT-1000/2000II FRONT PANEL
1. Rack Mounting Ears - Two front panel mounting holes are provided on each
mounting ear.
2. Fan Inlet Grills and Filter - MT Series amplifiers are cooled by one single rear-
mounted fan. Cool air from front grills is filtered and flows over the heatsinks
and exhausts to back side. Make sure these outlets remain clear to allow
unrestricted air flow.
3. Channel 1 Signal Indicator - This green LED will glow when there is an input of
the audio signal into channel one.
4. Channel 1 Clip Indicator - The red clip LED will begin to flash when the channel
begins to overload. At this point the channel will begin to distort. Under heavy
clipping activity, lower the channel's gain control to reduce the risk of damage to
your speakers and amplifier. This LED may glow when the unit has been turned
off, this is normal.
5. Channel 1 Protect Indicator - The red protect LED will begin to glow when the
channel goes into protect mode. When the channel goes into protect mode, all
output for the channel will turn off. This is to protect any speakers connected to
the channel.
6. Channel 1 Gain Control - This rotary knob is used to control the output signal of
channel one. Tuning the knob in clockwise direction will increase signal output.
7. AC Power Switch - MT-1000II amplifier has a front-panel AC mains power
switch.
8. Power Indicator - This LED will glow when mains power is applied to the unit.
This light may continue to glow briefly after mains power has been turned off,
this is normal.
9. Channel 2 Gain Control - This rotary knob is used to control the output signal of
channel two. Tuning the knob in clockwise direction will increase signal output.
10. Channel 2 Protect Indicator - The red protect LED will begin to glow when the
channel goes into protect mode. When the channel goes into protect mode, all
output for the channel will turn off. This is to protect any speakers connected to
the channel.
11. Channel 2 Clip Indicator - The red clip LED will begin to flash when the
channel begins to overload. At this point the channel will begin to distort.
Under heavy clipping activity, lower the channel's gain control to reduce the
risk of damage to your speakers and amplifier. This LED may glow when the
unit has been turned off, this is normal.
12. Channel 2 Signal Indicator - This green LED will glow when there is an input
of the audio signal into channel two.
page 3
Figure 2
Figure 1
Important Precautions Introduction Rear Panels Set Up Operating Modes Protection Features Specifications
Front Panels
UNiKA MT-1000/MT-2000II
PROTECT
CLIP
SIGNAL
PROTECT
CLIP
SIGNAL
CHANNEL 1 CHANNEL 2
MIN MAX MIN MAX
MT-1000
CLIP
SIGNAL
CHANNEL 1 CHANNEL 2
MIN MAX MIN MAX
PROFESSIONAL STEREO AMPLIFIER
MT-2000 II
PROTECT PROTECT CLIP
SIGNAL
UNiK A
1 2 3 6 4 5 7 8 9 12 11 10 1 2
1 2 3 6 4 7 8 9 12 11 1 2 5 10