Unigraf UCD-2 VX1, Руководство пользователя

Страница: 7 / 23

7
Sync Out, Sync In
Synchronization output and synchronization input for master slave configuration of
capturing multiple parallel channels.
Pin Description
1. Tip Signal 1
2. Ring Signal 2
3. Sleeve Ground
Status LEDs
LED operations of UCD devices are firmware dependent and subject to change excluding
power good which is always available. Functions for each LED are described in the figure
below.
UCD-2 Vx1
LED Description
1, 3, 9, 11 On = V-by-One symbol lock
2, 4, 10, 12 Flashing = FW running
6, 8 On = Power good
7 For chained devices: On = Master, Off = Slave
5 Unused
The table below shows the pin-out of one connector. Please refer to chapter Connecting
Source Devices later in this document on allocating data to the two connectors.
Channel A is for the data of ODD and Channel B of EVEN pixels. N/C = No Connection
50 GND Signal Ground
51 N/C N/C / Not in use