P31003C1020M1000276A9, 01/2018
OpenScape Cordless IP V2, Administrator Documentation
9
First steps
Package content
2 First steps
2.1 Package content
• One BSIP2
It can be used as DECT management system or as base station
• Two antennas
• Security leaflet
2.2 Preparing to use the telephone system
To use the telephone system the following steps must be performed:
1 Perform DECT measurement and site planning
During the planning phase of your DECT network you should have created an installation plan for the DECT
managers and base stations.
2 Connect the devices to the local network
3 Configure one device as Integrator/DECT manager
4 Mount the devices at the planned locations
Note:
For each location please note down the MAC address of the device you are going to
install.
5 Configure the local network settings via web configurator
You need a PC connected to the local network, so that you can configure your telephone system
via the web configurator.
6 Perform a firmware update
Note:
To ensure that the latest, best default initialisation of customer settings come into effect,
proceed as follows:
• Once again, reset the DECT manager device as Integrator/DECT manager via web configu-
rator ( p. 85) or key procedure ( p. 15). This will apply the default initialisation of customer
settings.
• If applicable, configure the local network settings via web configurator.
• Then perform the firmware update. This should be done
•not to update the device again (it is already up to date)
•but to provide the update software (or URL) for base stations to be added in the next step.
That information was lost by the previous reset procedure.
7 Register the base stations to the DECT manager
Note:
The base stations will go offline for the time of firmware update, i.e., that you may have
to wait a short time until you can continue with step 8.
8 Configure the base station synchronization
9 Configure VoIP Communication System or provider
