Fitting Instructions
UH9000S / UH9060S / UH9080S
Page 12 of 12
Alternate Speaker Microphone Hanger Location
Speaker Microphone
1.
Hang the speaker microphone on the hanger and connect
the cable to the UHF CB transceiver. Ensure the speaker
microphone cable routing does not interfere with any of the
vehicle’s controls.
NOTE: Models UH9060S / UH9080S are supplied with a
speaker microphone extension cable which can be used if
required.
WARNING
If the indicated location is not suitable, do not install the
hanger and speaker microphone in a location that may
interfere with the operation and deployment of the SRS
airbags or seatbelt pretensioners, including driver, front
passenger and knee SRS airbags if fitted. Doing so may
result in serious injury or death.
COMPLETION
IMPORTANT
1.
Ensure the interior wiring and any excess antenna cable
is positioned to avoid fouling and rattling (cable tie as
required at a minimum of every 200 mm. Use self-adhesive
cable tie mounting blocks where necessary).
2.
From the engine bay side, seal the antenna cable grommet
entry point with an automotive grade sealant and secure
with insulation tape.
3.
Neatly cable tie the antenna cable to the existing engine
bay wiring harness where indicated to avoid fouling,
rattling or a possible rubbing condition.
4.
Refit all remaining interior and exterior parts previously
removed.
5.
Check UHF CB transceiver operation.
