Remote Interface
You can communicate and program your UBC785XLT in numerous ways with peripheral
devices using the Remote Interface Cable port (the serial cable is optional). This radio offers
the following modes:
❖
PC Control mode
Program and control your scanner from a PC using optional ARC785 software.
❖
Clone mode
Clone all the frequencies into your scanner to another UBC785XLT.
PC Control Mode
To connect Scanner to PC:
Plug the scanner end of the RS232C straight cable into the remote port which is on the rear
of the scanner. Plug the other end of the cable (DB-9 serial connector) into a personal
computer’s serial port. A few PC’s may require an adapter, most will not. Of course, make
sure your PC is turned ON.
To program your scanner:
You can program and control your scanner remotely from a PC using optional ARC785
software.
After connecting the scanner to a PC, turn the scanner ON.
To use the Remote (PC Control) mode, you must install optional ARC785 software and use
as directed. Make sure that your scanner is connected to the serial port of the PC using the
RS232C straight cable.
40
UB343ZH_UBC785XLT_OM_0622 6/22/06 3:01 PM Page 40
