Uniden TRU9380 Series, Руководство пользователя

Страница: 52 / 67

51
Resetting the Handset Without the Base
If your original base is not available for some reason (for example, it is lost or somehow incapacitated), you can still
reset the handset and use it with another base.
Press and hold [ ] and [#] for at least 5 seconds.
Move the cursor to select REPLACING BASE and then press [select/ ] . REPLACE BASE appears.
Move the cursor to select YES, and then press [select/ ]
<RXKHDUDFRQ¿UPDWLRQWRQHDQGWKHKDQGVHW
deletes its own base information without contacting the base. The handset displays MODELS VARY! CHARGE
HANDSET ON THE BASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL.
Register the handset to the new base (see Registering Accessory Handsets on page 18).
Changing the Digital Security Code
7KHGLJLWDOVHFXULW\FRGHLVDQLGHQWL¿FDWLRQFRGHXVHGWRFRQQHFWWKHKDQGVHWDQGWKHEDVH<RXUXQLWVKLSVIURPWKH
manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation that you
suspect another cordless telephone is using the same security code or if you are instructed to change this code by a
manufacturer’s Call Center Representative, you can change the code. To change the digital security code:
Reset the handset (see Resetting the Handset on page 50).
Re-register each handset (see Registering Accessory Handsets on page 18).
Traveling Out of Range
During a call, if you move your handset too far from your base, noise may increase. If you pass the range limit of the
base, the handset will beep, display OUT OF RANGE, and then go to standby. The base will maintain the connection
for 30 seconds after the handset goes out of range. If you move the handset back within range of the base within 30
seconds, press [
ÀDVK@
or [ ] to pick up the call again.
1.
2.
3.
4.
1.
2.