Uniden Pro12800N0-4K, Быстрый старт

Страница: 11 / 16

11
_______ Add IP cameras.
Change IP address of each camera to put it in the same range as the network
connector (LAN1 or LAN2) that the camera is connected to. Connect Success
displays.
_______ Add Channels to Preview Groups
From Channel Setting/Channel Grouping , set up Preview Groups .
_______ From Channel Setting/Channel Grouping/Tour (right column), set up Tour Groups if
desired.
_______ Check and adjust camera images for focus and field of view in Preview .
_______ From Preview, set up PTZ Presets , Cruise , and Pattern .
_______
Set individual camera settings for each channel if desired:
Other areas to set up include but are not limited to:
• Motion Detection (From Channel Setting/Channel Parameter/Motion top tab.
• Privacy Mask (From Channel Setting/Channel Parameter/Privacy Mask tab.
• Snapshot Parameters (From Channel Setting/Channel Parameter/Snapshot
Parameters tab.
• Video Tampering (From Channel Setting/Channel Parameter, Video Tampering
tab.
COMPLIANCE
FCC PART 15
The equipment has been tested and found to comply with the limits for a Class B device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could
void your authority to operate the equipment. Any change or modification must be approved in
writing by Uniden.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Tout changement ou modification non approuvé expressément par la partie responsable pourrait
annuler le droit à l’utilisateur de faire fonctionner cet équipement. Tout changement ou modification
doit être approuvé par écrit par Uniden.
Avis de conformité à la FCC : Ce dispositif a été testé et s’avère conforme à l’article 15 des
règlements de la Commission fédérale des communications (FCC). Ce dispositif est soumis
aux conditions suivantes: 1) Ce dispositif ne doit pas causer d’interférences nuisibles et; 2)