Uniden Pro12800N0-4K, Быстрый старт

Страница: 10 / 16

10
3. Check the Next time no longer display box in lower left corner. This series of screens will not
display for further startups.
4. Click Finish .
SYSTEM SETUP CHECKLIST
Follow this checklist to turn up the NVR system. Refer to the ProSeries NVR Installation Manual
for detailed procedures for these steps if needed.
INITIAL SYSTEM SETUP
_______
From Start/Guide , set:
• Default Language
• Display Resolution (Default - 1920 x 1080)
• LAN1 and LAN2 Network Settings
When finished, select
Next time no longer display
and click Finish .
_______
Go to System/Time Setting, Device Time tab and set:
• Device Time
• Date Format
• Time Zone
• Enable Daylight Savings Time and set start and end dates.
• Network Time Protocol (NTP) is enabled by default. Change to internal time source
if desired. Turn off if the customer does not want the recorder to go out on the
internet.
_______ The recording schedule default is for all cameras to record all the time ( Channel
Setting/Schedule Setting/Recording Setting ). Set up specific recording schedules.
_______ From System Setting/User Management , set up new users and change the Admin
password.
_______ From System Setting/Alarm Management/Alarm Input (or Alarm Output ) top tab, set
up alarm inputs and outputs.
_______ From System Setting/Network Parameter/Email Setting top tab, set up email
notification.
_______ From System Setting/Network Parameters/DDNS Setting top tab select Enable DDNS
to set up remote DDNS access.
_______ From Maintenance/System Information/Device Information top tab, update firmware if
desired. (The device will automatically reboot after upgrade.)
HARD DISK DRIVE (HDD) SETUP
_______ Go to Disk Manager/Storage Management and uncheck Missing Alarm for all non-
installed HDDs.
_______ From Disk Manager/Storage Management , verify HDD quantity and sizes. Shut down
and add HDDs if needed.
_______
Set up Redundent Array of Independent Disks (RAID) array (for systems 36 channels
or greater).
• Set up RAID type and format.
• Assign cameras to HDDs/RAID.
NOTE: Pre-installed HDDs are factory-formatted and ready for use.
ADD IP CAMERAS
_______ Plan and set up IP addresses.