Initial Setup
Configuring the MER 9600C
Before you can place or receive calls, you must configure your
MER 9600C
to match the operation of your host telephone. You
must configure one of the Function Buttons (1 – 4) as your primary
extension.
If you press
talk key before
you configure the phone, you
will see an error message on
the LCD:
1. Remove the handset from the base unit.
2. Press and hold the
and
#
keys at the same time.
3. While holding
and
#
, press the
talk key.
4. Release all 3 keys. You will
now see a message on the
LCD prompting you to
configure the
F1 function key.
Note:
You can assign any function to F1 that you have on your
Host Telephone. For example; this can be a line key, call
forwarding key, pickup key, etc.
A * in the display indicates
that function key has already
been programmed.
5. Press the key on the Host Telephone that has the function you
want to assign to
F1. You will hear a beep to acknowledge that
the function has been assigned to the key, and a * will appear
to the lower right on the LCD.
6. You will see a new message
on the LCD prompting you to
configure
F2.
Follow the same procedure you used for
F1. Proceed in the same
way for
F3, F4, xfer, and conf.
NO CONFIG
PROGRAM
BTN F1
PROGRAM
BTN F1
*
PROGRAM
BTN F2
23
