12
13
Cruise Setup
STEP 1:
In PTZ control screen (refer to Image 1), click
SETUP
button
STEP 2:
Enter as shown in Image 3, click
SCAN
button and input the proper value in the scan value field.
STEP 3:
Click
START
button and enter as shown in Image 1 to set the zoom, focus, direction, etc. Click
SETUP
button to return
to screen as shown in Image 3:
STEP 4
: Click
END
button to complete the setup. Then, click the right button on the mouse to exit.
Cruise Calls
STEP 1:
As in Image 1, click
PAGE SHIFT
button and then enter PTZ control menu as shown in Image 2.
STEP 2:
Enter the number of scans in the value field then click
SCAN
button. PTZ will begin to work on the scan line.
Click
STOP
button to stop.
TROUBLESHOOTING
No camera movement or image at power-up.
• Possible cause: power connection issue.
• Solutions: Check the connections between the power supply and the camera. Connections should be clean and dry.
• Ensure that the power outlet is live.
• Confirm that the power supply is connected and working properly.
Camera displays image, but does not respond to commands.
• Causes/Solutions: DIP switch settings are incorrect – please see pages 6 and 7.
• RS485 connection is loose or not connected properly – please see page 9.
• The RS485 wires are broken. Check the wires for damage.
• Electrical interference. Use thicker or shielded wire.
Blurred image.
• Possible cause: Transparent dome is dirty.
• Solution: Use a damp, soft cloth to clean the dome. Do not use abrasive cleaners or solvents. Avoid harsh chemicals including
acetone as they may permanently fog the plastic.
Guardian PTZ Camera Quick Start Guide R7_cs2014.indd 13
2/22/17 12:52 PM
