Uniden EXP 7900 Series, Руководство пользователя

Страница: 5 / 12

Installation
Charging the Battery Pack
The rechargeable nickel-cadmium battery pack must
be fully charged before using your phone for the
first time. Before plugging the phone line into
your new phone, you must charge the
battery for approximately 15-20 hours
without interruption.
1. Remove the handset battery cover.
2. Plug the battery’s
cable into the
handset and
place the battery
pack inside the
battery
compartment.
3. Replace the battery cover.
t
Charging the Handset
Place the handset on
the base to charge. (The
handset can charge in
either the face-up or
face-down position.)
t
Low Battery Indicator
When the battery pack in the
handset is low and needs to be
charged, the
batt
LED flashes
every 3 seconds.
If this occurs while you are on
the phone, you will hear an alert
tone. Complete your call as
quickly as possible, and return the
handset to the base for charging.
t
Cleaning the Battery Contacts
To maintain a good
charge, it is important
to clean all battery
contacts on the handset
and base about once a
month. Use a dry cloth
or pencil eraser if necessary.
Do not use any liquids
or solvents.
Selecting a Location
Before choosing a location for your new phone,
there are some important guidelines you should
consider:
•
The location should be close to both a
phone jack and continuous power outlet.
•
Keep the base unit and
handset away from sources
of electrical noise such as
motors and fluorescent
lighting.
•
Be sure there is sufficient space to rotate the
Base Unit antenna to the vertical position.
Setting the Dial Mode
Most phone systems use tone dialing. Depending
on your dialing system, set the mode as follows:
1. Press and hold
flash
until you hear a
confirmation tone.
2. To set the dial mode for pulse dialing, press
#
.
Or to set the dial mode for tone dialing, press
/tone
. A confirmation tone sounds again to
indicate the setting is complete.
5
The plastic connectors will fit
together only one way. Make sure
the battery’s connector is properly
aligned. Use only the Uniden
battery pack (model BT-905).
A continuous power outlet is an
AC outlet which does not have a
switch to interrupt its power.
Important: Do not place the power
cord in an area where it may
create a trip hazard or become
chafed and create a fire or
electrical hazard.
Q
C:...Exp 7900 B of B.vp
Wed May 24 13:19:29 2000
Color profile: Disabled
Composite Default screen