Uniden DX8200, Руководство по эксплуатации

Страница: 44 / 54

USING
YOUR
DX8200
USING YOUR DX8200
44
PLACING A CALL ON HOLD
For example, to place line 1 on hold:
1. While you are on a call on
line 1
, press .
The line 1 LED flashes.
2. To pick up the call on hold, press or on the
Handset , or or on the Base Unit.
USING THE FLASH BUTTON (New Zealand Model only)
Press the button while operating from either the Handset or Base Unit.
This feature sends a timed “hook-flash” on the telephone line for accessing
services such as Call Waiting, etc.
ACCESSING CALL WAITING SERVICE USING THE FLASH BUTTON
(Australian Model only)
1. While talking, you hear the call waiting signal (series of beep tones).
2. Press key then to switch call and put the current call on hold.
3. To switch back to original call, press key then .
CHAIN DIALING
On certain occasions, after dialing a number, you may be requested by the party or
service you are calling to enter a special access code, such as when
performing a banking transaction. To store this number, refer to “Storing Memory
Dial Numbers” on Page 35.
For example, if your bank’s telephone number is stored in Base Unit memory
location 3, and your account number is stored in Base Unit memory location 4:
1. Press or or on the Base Unit.
2. Press on the Base Unit and number on the Base Unit keypad.
3. At the appropriate time, press and number on the Base Unit keypad.
4. Your Base Unit dials the number and you may proceed with your transaction.
NOTE: Use either the keypad on the Handset or the keypad on the Base Unit. Do not use
both keypads at the same time.
8200-OM.qxd 22/10/98 15:45 Page 44