Sheet 9
8) Finding a Lost Handset
To locate a lost handset, press
[find]
on the base. The handsets will beep for
sixty seconds. To cancel paging, press
[find]
again or press any key on the
found handset.
9) Maintenance
Specifications
The phone complies with FCC Parts and .
Operating
temperature
-0°C to +0°C (+4°F to +22°F)
AC Adapter
For the base
For the charger
Part number
AD-000
AD-30 or
AD-00
Input Voltage
20V AC 0Hz
20V AC 0Hz
Output Voltage
9V DC 20mA
9V DC 20mA
Battery
Part number
BT-00
Capacity
00mAh, 3.V
Frequency
924.92 - 92.70442 MHz
2,40.942 - 2,4.744 MHz
Note: To avoid damage to the phone use only Uniden AD-0001,
AD-310 or AD-1010 and BT-1006 with your phone.
Specifications, features, and availability of optional accessories are all
subject to change without prior notice.
Power Failure
During the period that the power is off, you will not be able to make or
receive calls with the telephone.
Battery Life
With average use, your handset battery provides approximately six hours of
talk time and approximately seven days of standby time. You can achieve
optimum battery life and performance by returning the handset to the base or
charger cradle after each use. When your handset is left off of the cradle, the
battery will gradually discharge even if the handset is not being used. The
actual talk time duration will be reduced in proportion to the amount of time
the handset is off of the cradle.
Low Battery Alert
When the battery pack is very low and needs
to be charged, the phone is programmed to
eliminate functions in order to save power. If the
phone is not in use, LOW BATTERY appears
on the LCD and none of the keys will operate. During a call, LOW BATTERY
flashes and the handset beeps. Complete your conversation as quickly as
possible and return the handset to the cradle for charging.
Note: Information stored in the phone's memory will be retained for
thirty minutes after the battery pack is removed. This includes all
setup information, last number dialed, speed dial memory, and the
CID list.
Even when the battery pack is not being used, it will gradually discharge
over a long period of time. For optimum performance, be sure to return the
handset to the cradle after a telephone call.
Battery Replacement and Handling
Recharge your phone on a regular basis by returning the handset to either
cradle after each phone call. When the operating time becomes short even
after a battery is recharged, please replace the battery. With normal usage,
your battery should last about one year. To order replacement batteries,
please contact Uniden’s Parts Department. The contact information is listed
on the back cover page.
Warning:
To avoid the risk of personal injury or property damage from fire or
electrical shock, only use the Uniden battery model and Uniden adapter
model specifically designated for this product.
Caution:
Use only the specified Uniden battery pack (BT-1006).
Do not remove the battery from the handset to charge it.
Never throw the battery into a fire, disassemble it, or heat it.
Do not remove or damage the battery casing.
Cleaning the Battery Charging Contacts
To maintain a good charge, clean the charging contacts
on the handset once a month. Dampen a cloth with plain
water.
Gently rub the damp cloth over the charging contacts until
all visible dirt is removed. Dry the contacts thoroughly
before returning the handset to the cradle.
Caution:
Do not use paint thinner, alcohol, or other chemical products. Doing so
may discolor the surface of the telephone and damage the finish.
•
•
•
•
Low Battery
Low Battery
Contacts
Contacts
