21
SUGGESTION
• Check for the telephone line cord connectors
at both ends that they are pushed in firmly
until they click.
• If you had a power failure or had unplugged
the base unit, replace the handset on the base
unit for two to five seconds to reset the system.
• You may have exceeded the Ringer
Equivalence Number(REN) limit of how many
phones can be connected to the same line.
The REN total of all devices(printed on the
bottom label of each unit) should not exceed
three(3). Disconnect the appropriate units to
lower the REN total.
• Check the Ni-Cd battery pack connection
inside the battery compartment on the handset.
• The handset rechargeable Ni-Cd battery pack
may need to be charged.
• Make sure the charging contacts on both the
base unit and the handset are in contact during
charging.
• The charging contacts may need to be cleaned
refer to page 5, No 3 or page 14.
• The Ni-Cd battery pack may need to be
discharged first before a full charge.
• Raise or reposition the antenna on the base or
handset.
• Move the base unit so that it is centrally
located in your residence or office and make
sure that the base unit is not located near
appliances.
• The handset rechargeable Ni-Cd battery pack
may need charging.
• You may be out of normal operating range.
Move closer to the base unit.
• When storing phone numbers, make sure that
the handset is in the standby position.
• When recalling stored phone numbers, check
first for a dial tone.
• Always use two digits when entering/recalling
memory index numbers.
Cannot store or
recall phone
numbers from
memory
PROBLEM
No dial tone
Calls received
flutters or
fades
Range is
limited
Does not
charge
No power on
the handset
unit
Does not
ring
DG 910 operating guide 2/3/99 12:56 PM Page 21
