background image

 6 

1) Press 

select/

 on the handset in standby mode.

2) After the announcement, enter a command in the following list within 

30 seconds.

3) To quit, hang up or press 

end

.

• If you press 

end

 before the answering system answers, the phone 

will return to standby mode.

• When the answering system does not answer within 6 seconds, you 

will hear a beep and the phone will return to standby mode.

• When you receive a call, remote operation is canceled.

I.C. Notice

TERMINAL EQUIPMENT

NOTICE:

 This equipment meets the applicable Industry Canada Terminal Equipment Technical 

Specifications. This is confirmed by the registration number. The abbreviation, IC, before the 
registration number signifies that registration was performed based on a Declaration of 
Conformity indicating that Industry Canada technical specifications were met. It does not 
imply that Industry Canada approved the equipment.

NOTICE:

 The Ringer Equivalence Number (REN) for this terminal equipment is marked on the 

equipment itself. The REN assigned to each terminal equipment provides an indication of the 
maximum number of terminals allowed to be connected to a telephone interface. The 
termination on an interface may consist of any combination of devices subject only to the 
requirement that the sum of the Ringer Equivalence Numbers of all the devices does not 
exceed five.

RADIO EQUIPMENT

The term “IC:” before the radio certification number only signifies that Industry Canada 
technical specifications were met.

Operation is subject to the following two conditions: (1) this device may not cause 
interference, and (2) this device must accept any interference, including interference that 
may cause undesired operation of the device. “Privacy of communications may not be ensured 
when using this telephone.”

THE FCC WANTS YOU TO KNOW

Changes or modifications to this product not expressly approved by Uniden, or operation of 
this product in any way other than as detailed by the owner's manual, could void your 
authority to operate this product.

Uniden works to reduce lead content in our PVC coated cords in our products and accessories.

Warning!

The cords on this product and/or accessories contain lead, a chemical known to the State of 
California to cause birth defects or other reproductive harm. 

Wash hands after handling

.

Command

Function

Command

Function

1

Repeat a Message

6

Answering System On

2

Playing incoming Messages

7

Memo Record/Stop

3

Skipping a Message

8

Greeting Message Record/Stop

4

Deleting a Message

9

Answer System Off

5

Stop Operation

0

Help Guidance

UU844BH(DCX640) OM.fm  6 ページ  2003年10月22日 水曜日 午後4時46分

Содержание DCT646 Series









Отзывы: