English - 17
RF Exposure Information
This product complies with FCC radiation
exposure limits under the following
conditions:
x
The base must be placed to allow a minimum
of 20 cm (8 inches) between the antenna and
all persons during normal operation.
x
The base must not be collocated or operated
in conjunction with any other antenna or
transmitter.
x
The handset is designed for body-worn
operation and meets FCC RF exposure
guidelines when used with any belt clip,
carrying case, or other accessory supplied
with this product. (All necessary accessories
are included in the package; any additional
or optional accessories are not required
for compliance with the guidelines.) Third
party accessories (unless approved by the
manufacturer) should be avoided as these
might not comply with FCC RF exposure
guidelines.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: This equipment meets the applicable
Industry Canada Terminal Equipment
Technical Specifications. This is confirmed by
the registration number. The abbreviation
IC
before the registration number signifies
that registration was performed based on
a Declaration of Conformity indicating that
Industry Canada technical specifications were
met. It does not imply that Industry Canada
approved the equipment.
NOTICE: The Ringer Equivalence Number
(REN) for this terminal equipment is marked
on the equipment itself. The REN assigned
to each terminal equipment provides an
indication of the maximum number of
terminals allowed to be connected to a
telephone interface. The termination on an
interface may consist of any combination of
devices subject only to the requirement that
the sum of the Ringer Equivalence Numbers
of all the devices does not exceed 5.
Radio equipment
The term
IC
before the radio certification
number only signifies that Industry Canada
technical specifications were met. Operation
is subject to the following two conditions: (1)
this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause
undesired operation of the device. "Privacy of
communications may not be ensured when
using this telephone."
Warranty (1 Year, Limited)
Evidence of original purchase is required
for warranty service.
WARRANTOR: UNIDEN AMERICA
CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants,
for one year, to the original retail owner, this
Uniden Product to be free from defects in
materials and craftsmanship with only the
limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the
original user shall terminate and be of no
further effect 12 months after the date of
original retail sale. The warranty is invalid if
the Product is (A) damaged or not maintained
as reasonable or necessary, (B) modified,
altered, or used as part of any conversion
kits, subassemblies, or any configurations
not sold by Uniden, (C) improperly installed,
(D) serviced or repaired by someone other
than an authorized Uniden service center
for a defect or malfunction covered by this
warranty, (E) used in any conjunction with
equipment or parts or as part of any system
not manufactured by Uniden, or (F) installed
or programmed by anyone other than as
detailed by the owner's manual for this
product.
STATEMENT OF REMEDY: In the event
that the product does not conform to this
warranty at any time while this warranty is
in effect, warrantor will either, at its option,
repair or replace the defective unit and
return it to you without charge for parts,
service, or any other cost (except shipping
and handling) incurred by warrantor or
its representatives in connection with the
performance of this warranty. Warrantor, at
its option, may replace the unit with a new
or refurbished unit. THE LIMITED WARRANTY
SET FORTH ABOVE IS THE SOLE AND ENTIRE
WARRANTY PERTAINING TO THE PRODUCT
AND IS IN LIEU OF AND EXCLUDES ALL OTHER