E-6
modulation. With MIC Gain active, press and hold the
PTT
button and adjust the gain levels with the
Channel Selector
knob. (Levels 00 - 04). The LED will stay on for 5 seconds after you
release the
PTT
button.
Weather:
Press to toggle between Weather and CB channels. Turn
Channel Selector
to cycle through the 7 weather channels. (LED
off = CB channels; LED on = Weather channels).
Press and hold to turn Weather Alert on and off.
ALERT
displays.
6.
Channel Selector/MENU/OK
. Press the inner
MENU/OK
button to
select a menu option or other selection. Turn the outer
Channel
Selector
knob to:
Select channels.
Select Night or Day Modes. Press
MEM/SCAN
to set up your
preferred day and night mode settings.
Select menu modes.
Change scan resume direction (up or down).
Control Talkback volume.
Control RF gain.
Control Mic gain level.
All channels except Channel 9 may be used for normal communication. The
FCC reserves Channel 9 for emergencies involving the immediate safety of
individuals or protection of property. Use Channel 9 to render assistance to
a motorist. This is an FCC rule and applies to all CB operators.
7. Microphone socket.
8. Indicators turn on when the function is turned on.
9.
S/RF/CAL/SWR
: Press to check RF signal strength, calibration, and
SWR reading.
10.
CB/PA:
Selects
CB
(Citizens Band) or
PA
(Public Address).
Do not use the PA function unless an external speaker is connected.
11.
MEM/SCAN
: Press to start or stop scanning modes [All Channel
Scan (see
page 10
) and Memory Scan (see page 12)]. Press and hold
to set or clear channel memory while in Memory mode.
12.
9/19/NORM
: Press to switch between emergency channel 9,
