Uniden BCD436HP, Руководство пользователя

Страница: 51 / 104

43
Set Base Freq
Input Lower. Enter the lower base frequency and press E/yes .
Input Upper. Enter the upper base frequency and press E/yes .
Set Offset
Input Offset. Enter the offset and press E/yes .
Select Polarity. Scroll to + (default) or - and press E/yes .
Set Spacing. Scroll to the step size and press E/yes .
Press Menu to return and repeat for each band plan as needed.
Set Frequencies – This is where you program trunking frequencies for the Site.
New Frequency/Edit Frequency . Enter the frequency and press E/yes .
For EDACS and LTR sites only:
Input LCN. Enter the LCN number and press E/yes .
Delete Frequency
At Confirm Delete?, press E/yes or ./no .
Set Modulation (no P25/P25 One Freq) – This setting selects the modulation used for the Site.
The default setting is Auto .
Auto , NFM , or FM
See also Scan Modulation.
Set Attenuator – This setting controls whether the scanner attenuates signals on the Site by
about 20 dB The default setting is Off .
On or Off
See also Scan Attenuation.
Set Avoid – This determines whether a Site will be scanned or not. Temporary Avoids cancel
when you cycle power. The default setting is Stop Avoiding .
Stop Avoiding, Temporary Avoid , or Permenant Avoid
See also Scan Avoids.
Set Location Information – This allows you program a location for the Site to use with Location
Control enabled or with a GPS. You can program a circle with a radial range or multiple rectangles
as a location.
See Set Up GPS first to set your location format and the Baud rate.
Circle
Set Latitude
Enter the latitude. Press ./no to toggle N or S , and press E/yes .
Set Longitude
Enter the longitude. Press ./no to toggle E or W , and press E/yes .
Set Range See also Understanding Range.
0-6000
Rectangles
New Rectangle
Latitude - Top Left
Enter the latitude. Press ./no to toggle N or S , and press E/yes .
Longitude - Top Left
Enter the longitude. Press ./no to toggle E or W , and press E/yes .