10
any other antenna or transmitter. End-users and installers must be provided with antenna installation
instructions and consider removing the no-collocation statement.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation
IC Regulations
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Symbol Conventions
IMPORTANT
Provides additional information to emphasize or supplement important points of the
main text.
WARNING
Indicates a potentially hazardous situation, which if not avoided, could result in equipment
damage, data loss, performance degradation, or unexpected results. Safety Instructions
Safety Instructions
These instructions are intended to ensure that a user can use the product correctly to avoid danger or
property loss.
Proper configuration of all passwords and other security settings is the responsibility of the installer
and/or end-user.
• In the use of the product, you must be in strict compliance with the electrical safety regulations of your area.
• Do not connect several devices to one power adapter as adapter overload may cause over-heating or a fire hazard.
• Please make sure that the plug is firmly connected to the power socket. When the product is mounted on
wall or ceiling, the device shall be firmly fixed.
WARNING
• Make sure the power supply voltage is correct before using the camera.
• Do not drop the camera or subject it to physical shock.
• Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit of ethanol
and wipe it gently. If the camera will not be used for an extended period, replace the lens cap to protect the
sensor from dirt.
• Do not aim the camera at the sun or extra bright places. Blooming or smearing may occur, and affect the
sensor’s endurance at the same time.
• The sensor may be burned out by a laser beam, so when any laser equipment is in use, make sure that the
surface of sensor will not be exposed to the laser beam.
• Do not place the camera in extremely hot, cold (the operating temperature shall be -10°C to +40°C), dusty,
or damp locations, and do not expose it to high electromagnetic radiation.
• To avoid heat accumulation, ensure that there is good ventilation to the device.
• Keep the camera away from liquids.
• If the product does not work properly, please contact your retailer or Uniden customer service.
• Never attempt to disassemble the camera yourself. (We shall not assume any responsibility for problems
caused by unauthorized repair or maintenance.)
Copyright ©2018 Uniden America Corporation, Irving Texas. ALL RIGHTS RESERVED.
