Manual – 3000 NRL Family
Unidata Manual - 3000 NRL Family - 17 09 2018.docx
Page 5
1.1
Neon Remote Loggers
There are many different models of Neon Remote Loggers available. While the models
may be different, and the interfaces available in various models are different, the basic
operation of all Neon Remote Loggers is the same.
Typical Neon Measurement System
1.2
Typical Neon Measurement System
The figure above is an example of a Neon installation showing an NRL connected to a
Modbus sensor. Every day the NRL will send, via the Inmarsat satellite network, to the
Neon server a “packet” of information containing the data in raw format.
The Neon Server then extracts the raw data from the packet. The data is then stored on a
secure server until the client accesses the data using a standard Web Browser.
The Neon Server receives, processes, displays, stores and reports collected data in many
ways.
The Neon Server also can issue control commands based on pre-set algorithms and issue
alarms and notifications via several mediums.
Alarm set points can be set up on the NRL units as well as the Neon Server and alarm
notifications can be sent via several methods including email and SMS text messages.
Alarm triggers can initiate physical actions in the field such as turning pumps on and off or
activating other control functions based on the internal program within the NRL.
The Neon system has fully bi-directional communications between the NRL and the Neon
Server. This allows for remote diagnosis, remote programming and remote firmware
updating for operation of the remote equipment and thereby reducing costly site visits.
NRL units can be configured to read sensors, log data internally to local memory and push
data to the central Neon server at user settable intervals such as once a minute, every
few minutes, every hour, or once a day.