unicraft SSK 2.5, Руководство по эксплуатации

Страница: 12 / 18

12 SSK 2.5 | Version 1.08
Troubleshooting
10 Troubleshooting
11 Disposal, recycling of used device
In your own interests and in the interests of the environ
-
ment, please ensure that all components of the equip
-
ment are disposed of in the proper and authorized way.
11.1 Decommission
Disused devices must be taken out of service immedi
-
ately in order to avoid later misuse and endangering the
environment or people.
Step 1: Remove all environmentally hazardous fluids
from the old unit.
Step 2: If necessary, dismantle the devices into mana
-
geable and usable assemblies and compo
-
nents.
Step 3: The device components and operating materi
-
als must be routed to the appropriate disposal
routes.
11.2 Disposal of lubricants
Remove any escaping, used or excess grease from the
lubricated lubrication points.
The disposal instructions for the lubricants used are pro
-
vided by the lubricant manufacturer. If necessary, ask for
the product-specific data sheets.
ATTENTION!
If any of the following errors occur, immediately stop
working with the sandblasting gun. It can cause
serious injury or damage to the tool.
All repairs or replacement work must only be carried
out by qualified and trained personnel. The tool must
first be disconnected from the compressed air
source.
Fault Possible Cause Remedy
the device is not working 1. Defective pedal
2. No connection to the compressed
air source
1. Replace the pedal.
2. Establish compressed air connec
-
tion.
Bad ray result 1. Worn jet nozzle
2. Compressor power insufficient
3. Working pressure too low 1. Replace blast nozzle.
2. Use more powerful compressor
3. Increase working pressure
There is not enough or no blasting
sprayed 1. Nozzle clogged
2. Venting on blasting jar blocked
3. Air pipe blocked on the material in
-
take nose
4. Too humid air
5. Line leaking
1. Clean or replace the nozzle
2. Clean the breather
3. Clean or replace the air tube
4. Insert water separator
5. Replace line
Pressure drop on the sandblasting 1. Compressed air line clogged or
with insufficient cross section
2. Compressed air line too long
1. Clean line or replace with larger
line
2. Lay the cables shorter