Unicorn LS2-H540, Инструкции по безопасности

Страница: 15 / 39

- 14 -
❶
❷
❻
❹
❼
❽
❸
❺
ꊝ ꊧ
❾
ꊝ ꊦ
☞ INSERT THE BOBBIN① ONTO THE BOBBIN WINDER SHAFT②.
☞ PUSH THE BOBBIN WINDER STOP LATCH③ ALL THE WAY DOWNWARD.
☞ WIND THE THREAD AROUND THE BOBBIN① A FEW TIMES(IN THE DIRECTION OF THE
ARROW), AND THEN OPERATE THE MACHINE.
☞ IF THE THREAD CANNOT BE WOUND EVENLY, LOOSEN THE THREAD GUIDE SCREW④, AND
MOVE THE THREAD GUIDE⑤ TO THE RIGHT OR LEFT.
☞ TO WIND THE THREAD ONTO THE BOBBIN, MAKE ADJUSTMENT BY TIGHTENING THE
SCREW⑥.
※ IN CASE OF ROTATION THE MACHINE WITHOUT SEWING KEEP THE PRESSER FOOT RAISED.
3. 윗실 끼우는 법 / HOW TO ROUTE THE UPPER THREAD
☞ 실채기를 최고의 위치에 올려놓고 그림과 같이 윗실을 끼워 주십시오.
☞ 실 끝을 약 50㎜정도 잡아 당겨 주십시오.
☞ RAISE THE THREAD TAKE-UP LEVER TO THE HIGHEST POSITION AND ROUTE THE
THREAD AS SHOWN IN FIG.
☞ PULL OUT THE END OF THE THREAD ABOUT 50㎜ THROUGH THE NEEDLE EYE.
4. 밑실 끼우는 법 / HOW TO ROUTE THE LOWER THREAD
☞ 북집에 실토리를 넣어 주십시오.
☞ 실을 실홈① 사이로 끼워서 실조절판 스프링②의 밑으로
걸어 주십시오.
☞ INSERT THE BOBBIN INTO THE BOBBIN CASE.
☞ PASS THE END OF THREAD THROUGH THE
SLIT①, AND PULL OUT THE THREAD.