01865 767676
www.unicol.com
3
Revised 24/07/21
STEP 1
Place trolley base on a flat surface and apply
brakes by pressing down levers on each castor.
Loosen the grub screws on the back of socket
upstands and place a column in each socket.
Tighten grub screws until they just touch columns.
Do not tighten fully. Thread power and signal
cables through base sockets and columns.
NOTE:
If fitting an accessory, please see page 4.
STEP 2
Loosen grub screws in mount adapter sockets.
Place over the columns and thread cables through.
Column edges should be level with the tops of the
top socket caps. Tighten grub screws so they just
stop the adapter from sliding down the columns.
Tighten all grub screws (base and mount adapter).
STEP 3
Fit the PZX9 backplate to the mount adapter.
Secure into the backplate rivnuts with the 4 x M10
x 25 hex-head screws through the 300 x 300 fixing
holes in the mount adapter. Thread cables through
central apertures in mount adapter and back plate.
STEP 4
Using the griplock (top) and taglock (bottom)
spacers fix the mount arms to the screen
fixing holes. Choose the correct manufacture
recommended fixing screws for your screen from
the universal fixing pack supplied.
