Uniclass DX120, Руководство пользователя

Страница: 20 / 24

20
Momentary switch
Momentary switch 1 (Sw1):
1. Short press to switch on and off remote console.
2. Upgrade the firmware (refer to chapter of
Upgrade
).
Momentary switch 2 (Sw2):
1. Short press to select the Graphic Mode / Video Mode . You may select an appropriate viewing mode
depending on the speed of connected network.
Graphic mode: Stream the video in higher quality.
Video mode: Remain a watchable quality at lower bitrates.
2. Long press to select the Anti-Dither 1 / 2 / OFF.
3. Detect the EDID of connected monitor.
If the resolution of the display reduces to 640x480 or other settings from 1080P, it means the EDID of
the connected monitor may not be detected. Please follow the steps below to detect the EDID of the
connected monitor if this happens. Note that this procedure is only available on Receiver (RX) unit.
3-1. Remove the power adapter from Receiver (RX) unit.
3-2. Press the SW2 and then re-connect the power adapter.
3-3. Release the SW2 when the LED flashes red. The EDID of monitor should be detected after
completing this procedure.
Configuration
To configure the system, a web user interface is provided. Users can easily access and configure what
they need. Please follow the steps below for more operations.
• Please contact with authorized service, local dealer or distributor for more support if you have trouble
to update.
1. Connect a PC to the same network of the extender system.
2. Unplug the power of the unit you wish to access if the power is on.
3. Press and hold down the Momentary Switch button (SW1), and then plug on the power. Release the
SW1 button until the Power and Link LED blink alternately, it may take about 20 seconds to wait.
4. Open a browser and enter the address of “ 192.168.0.88:80 ” to login the webpage.