UNIA ARES P, Руководство по эксплуатации и техническому обслуживанию

Страница: 26 / 34

OPERATING AND MAINTENANCE MANUAL ARES P / ARES ROLLER UP
- 24 -
4.6 Operation (see par. II Safety)
Before beginning the field work with the machine:
• disassemble the warning signs (together with the screwed brackets) for
transport on highways
• unfold the foldable units to the working position
•
switch the hydraulic system to the position or mixed control mode
Adjust the cultivator during the first passage. When the unit is correctly levelled, its frame is parallel
to the ground. When the cultivator becomes clogged with excessive amount of plant debris, clean it
by lifting up on the tractor hydraulic lift for a while.
5. Servicing and Maintenance
5.1 General
• Always use the genuine spare parts since they are of the proper quality and fit
the machine correctly. Besides, it is one of the warranty conditions.
• Always set the machine on a hard and flat surface, supported by wheels and
supports before beginning any work at/on it. Disconnect it also from the
tractor
CAUTION! THE HYDRAULIC SYSTEM IS PRESSURIZED!
CAUTION! THE LIGHTING SYSTEM IS LIVE!
5.2 Replacement of Working Parts
•
Replace all working parts (wearing parts) in due time to protect
the other, more expensive assemblies against wear.
• Contact the manufacturer’s service department in order to replace
any component of the hydraulic system and springing.
5.3 Hydraulic System
•
Drain all oil remaining in the hydraulic system before first start and fill the system with oil
recommended and used in the tractor connected to the machine.
•
Check the hydraulic system and cylinders for leaks every day and remove any leakages as
soon as possible.
• Take care of the cleanliness of the cylinders and especially their piston rods.
• Set the machine in the parking position, and depressurize the system before beginning any
work at the hydraulic system.
• Only connect and disconnect the hoses to and from the tractor when the hydraulic system is
depressurized.
• Replace the hydraulic hoses after five years of operation of the machine at the latest.