UNIA ARES L 2.5, Руководство по эксплуатации и техническому обслуживанию

Страница: 25 / 34

OPERATING AND MAINTENANCE MANUAL ARES L
- 28 -
The service is limited to control the tightness of the system and replacing elements that bear
traces of mechanical damage. At least twice a year, and especially before winter, you should
dewater the pneumatic system. To do this, unscrew the plug
[1] Fig. 20 in the lower part of
the air tank [2] Fig. 20 by 3 to 4 turns. This will squeeze the water collected in the tank. After
removing the water, the plug must be re-tightened and the installation checked for leaks.
Fig. 23. Dewatering of the pneumatic brake system
3.5.10 Seeder support adjustment (hydropak option - ARES L 2.5; 3.0; 3.5; 4.0)
The seeder support can be adjusted in three
directions:
• front-back:
unscrew the screws [B], set the appropriate position
of the base, adjust the screws and tighten them
• up-down:
unscrew the screws [A], set the appropriate position
of the base, tighten the screws
•
tilt angle
loosen the bottom screw [C] , unscrew and remove
the screw [D] , set the appropriate angle of support
inclination, adjust the screws [D] to the holes [F] ,
tighten the screws
Fig. 24. Seeder support adjustment
3.5.11 Support wheel adjustment (option)
The support wheel
[A]
can be adjusted using the
turnbuckle [B]. Rotate the turnbuckle so that the
support wheel will get up or down.
Fig. 25. Support wheel adjustment ARES L
4.5;6.0 (option)