UNI ACP Series, Техническое и эксплуатационное руководство

Страница: 7 / 14

2-3 OPERATION CONCEPT
● Voltage Variation
The output voltage was designed to be linear adjusted variably using volume with power TR
PAM control type among 0 ~ 300V according to the status of voltage range.
● Frequency Invert
The output frequency was designed for input 60Hz to be inverted using PAM control type
and 40 ~ 999Hz frequency is output.
SECTION 3
OPERATION
3-1 PREPARATIONS BEFORE USE
● The hear generated by AC Power Source is released thru rear panel so please place the
machine minimum 10cm away from other equipment or wall so that the air flow goes on
smoothly.
● Do not place any articles in the base and side of the machine so that the air flow goes on
smoothly without closing air ventilation holes.
● Do not place the machine to be exposed direct to the sun or eroded gas.
● Do not place the machine in the room with vibration or lots of dust.
● Do not operate the machine if there is some damage with fuse holder, panel meter,
switches and other mechanical parts.
3-2 ELECTRICAL CHECK
1. Turn both Electric Source Switch and Power Switch OFF.
2. Place all Voltage Adjust VR at the minimum range.
3. Adjust Frequency Preset Volume to the range to be desired.
4. Check whether the input power voltage to be used is the same as single phase AC
220V/60Hz.
5. Connect AC input terminal of the machine with power source.
6. Turn the Power Switch ON and check if the frequency counter is displayed.