UNI-T UTG9000C-II Series, Руководство пользователя

Страница: 9 / 29

Chapter 3 Quick Start
3.1 General Inspection
When you get a new function/arbitrary waveform generator, you are advised
to inspect the instrument according to the following steps.
3.1.1 Inspect Whether Damage is Caused by Transportation
If the packaging carton or foamed plastic supplementary mat is seriously
damaged, please contact with dealer of the product or local office.
If the instrument is damaged during transportation, please keep the package,
and notify transportation department and dealer of the product, who will
arrange repair or replacement.
3.1.2 Inspect Accessories
UTG9000C-II accessories include: a power cord, a USB data cable, a BNC
cable (1m), a user CD and a product warranty card.
In case of lack or damage of accessories, please contact with dealer of the
product or local office.
3.1.3 Inspect Complete Machine
If appearance of the instrument is damaged, the instrument runs abnormally
or fails to pass performance tests, please contact with dealer of the product
or local office.
3.2 Adjust The Handle
The handle position of the UTG9000C-II Series DDS Function/Arbitrary
Waveform Generator can be adjusted freely. Just hold the handle on both
sides and pull outwards, then rotate the handle to the desired position.
As shown in picture 3-1 below:
Picture 3-1 Handle adjustment
3.3 Output Basic Waveform
3.3.1 Set Output Frequency
The default configuration of waveform is a sine wave with frequency of 1kHz
and amplitude of 100mVpp (terminating at 50Ω).
The specific steps for changing frequency into 2.5MHz are as follows:
Press the Freq button, and use the numeric keypad to enter 2.5, then select
the parameter unit .
3.3.2 Set Output Amplitude
The default configuration of waveform is a sine wave with amplitude of
100mVpp (terminating at 50Ω).
The specific steps for changing amplitude into 300mVpp are as follows:
Press the Ampl button, and use the numeric keypad to enter 300, then select
the parameter unit .
UTG9000C-II User Manual