T
www.ungerglobal.com
Factor
DIUH1
DIUH2
DIUH3
Weight incl resin
10 kg
22 kg
31 kg
Height
35 cm
76,5 cm
107 cm
Inner Diameter
20 cm
20 cm
20 cm
Dimension of base
28 x 30cm
28 x 30cm
28 x 30cm
Ultra Resin Packs
1x
1x , 2x
1x , 2x
Max. permanent pressure (bar)
max. 8
max. 8
max. 8
Max. water temp. (°C)
30
30
30
Min. water temp. (°C)
5
5
5
7. Technical Data
O
M
L
30mm
19mm
N
14
HydroPower® Ultra
Dynamic Flow Control
Technical Data
6.3 Dynamic Flow Control
The ideal water flow for regular glass cleaning in this system is 120l/hour.
Depending on the regional water pressure it is possible that more water is
produced than consumed.
To make the performance of HydroPower
®
Ultra independend from incoming
water suppply pressure, the dynamic water flow controller included with the filter
can be used. It reduces the water flow to 2l/minute (= 120l/hour). Optimising the
water flow in this way allows you to use less water, extending the lifetime and
performance of a single resin refill.
You can easily insert the Dynamic Flow Control:
1. Remove the bottom connector. You will need a 30mm and a 19mm wrench
(fig. L).
2. Use the 19mm wrench to hold the front nut and the 30mm wrench to loosen
the rear nut (Fig. M). Loosen the rest by hand and remove the front part of
the connector.
3. Insert the dynamic water flow control into the opening, wide white rim
towards the inside. (Fig.N)
4. Mount the adapter again using the two wrenches. Tighten the two nuts by
hand.
If you want to remove the dynamic water flow regulator proceed in the same way
and push it out from behind in step 3 with a screwdriver carefully. (Fig.O)
Note:
By reducing the flow it will take longer to fill a pure water vessel / storage tank.
