UNAOHM
2
NG500 (Rev. 0)
MARK
This instrument is in conformity with the following standards and documents:
EN 50082-1 - EN 55011 - EN 61000-3-2 - EN 61000-3-3 - IEC 801-2
IEC 801-3 - IEC 801-4
Safety Regulation EN 61010-1
1.
WARNING
The below-indicated safety precautions and general warnings must be carefully observed during
all phases of use, maintenance and servicing of the instrument to avoid damages to persons,
animals and property.
UNAOHM S.r.l. assumes no responsibility for incorrect use of the
instrument or if the norms specified are not followed.
1.1.
SAFETY PRECAUTIONS
•
Power the instrument with a voltage within the limits indicated in the specifications
.
•
This instrument has been designed for indoor use. Do not expose it to rain or dripping.
•
Do not use the instrument in explosive environments due to the presence of gas or
inflammable fumes or dust.
•
Do not turn on the instrument immediately after transferring it from a very cold place to a hot
one, to avoid condensation.
•
Do not obstruct the instrument’s cooling slit fenditures or place it near strong sources of heat.
•
For prolonged use in the lab or in fixed places, the instrument should be removed from the
carrying case to allow for better heat dissipation.
•
Do not apply DC or RF voltages to the input connectors that are higher than those indicated.
•
We recommend periodic inspection of the carrying strap, the relative fasteners, and the clips
since they could be damaged with use. As soon as a sign of wear is noticed, substitute them.
•
When the instrument is equipped with a battery, we recommend:
1) Do not shortcircuit the battery since it may explode.
2) Do not immerse the battery in water or place it in a flame.
3) Do not perforate or try to open the battery.
4) When substituting the battery, use a similar one and dispose of the old one in the special
ecological disposal containers.
5) Do not connect the battery with inverted polarity.
