EN-7
Filling the water tank
Option 1:
To add water to the water tank (13), hold the device at a 45° angle. Open the water tank cap (11) by turning
it counterclockwise. Fill the measuring cup (J) with clean water. Add water into the water tank (13)
and then close the water tank cap (11) once the tank has been filled to the maximum level by turning it
clockwise.
Option 2:
Remove the water tank (13) from the main body (A) by pressing the water tank buttons (12).
Open the water tank cap (11) by turning it counterclockwise. Add water into the water tank (13) by holding
the water tank under the running water tap or by using the measuring cup (J). Close the water tank cap
(11) once the tank has been filled to the maximum level by turning it clockwise. Then insert the water tank
back by pressing it in the main body (A) until you hear a click.
Note! When the water tank is full, it can work up to approximately 20 minutes.
Filling the detergent tank
Open the cap of the detergent tank (14) by turning it counterclockwise, and add the detergent.
Then close the cap of the detergent tank (14) by turning it clockwise.
Press the detergent ON/OFF button (15) if you want to use detergent during cleaning, for instance when
the object to be cleaned is stained with grease or oil.
When the detergent ON/OFF button (15) is low, the detergent is ON
When the detergent ON/OFF button (15) is high, the detergent is OFF
Power ON/OFF
Make sure the power ON/OFF switch (7) is in the off “O” position.
Once the device is fully assembled and the water tank has been filled with water, fully unwind the power
cord (6) and plug it into a grounded socket.
To power ON the device, press the power ON/OFF switch (7) to the on “I” position. The LED indicator lights
(9) will turn red at each side of the water tank (13), indicating it is preheating.
Note: It is normal for a little bit of water to be ejected from the nozzle before steam starts to appear.
It takes ± 20 seconds to preheat. When the LED indicator lights (9) in the water tank light up blue, the mop
emits steam automatically and is ready for use.
To power OFF the device, press the power ON/OFF switch (7) to the off “O” position.
Note!
When powering ON the device it will always automatically start prehearing.
Steam control
You can control the emitted steam level by turning the steam control knob (10).
• Turn the steam control knob (10) clockwise to increase the emitted steam
• Turn the steam control knob (10) counterclockwise to decrease the emitted steam
Slowly pass over the intended surface. It is recommended to sweep or vacuum the floor prior to using the
device.
Содержание UZ-CL-STCL01
Страница 1: ...USER MANUAL MODEL UZ CL STCL01 ...
Страница 2: ......
Страница 51: ......
Страница 52: ...Version 18 6 2020 ...