Umarex LaserLiner AutoCross-Laser ACL 3 RX, Руководство по эксплуатации

Страница: 6 / 10

Plumb definition:
Through the laser cross at the top, a plumb line can
be projected from the floor to the ceiling. To do this,
centre the adjusting plate on the desired projection
point. Then screw the base (6) onto the device and
position in the centring holes (9) of the adjusting
plate (8). Now switch the device on (switch 4) and
select the appropriate laser (button 14). The laser
cross at the top is now exactly perpendicular above
the desired projection point.
IMPORTANT: The tilt function must be activated
(control lamp 12 on)
Working with the laser receiver RX 50:
For levelling over longer distances or in conditions of bright light, use the
laser receiver RX 50. Switch on with button D; control lamp A will light up.
IMPORTANT: Set the ACL 3 RX to hand receiver mode
(button 10). The laser lines will now pulsate with high
frequency (10 kHz), making the laser lines darker. The
laser receiver can detect these pulsating laser lines up to
a maximum distance of 50 m.
Now move the receiver field (F) of the laser receiver
through the laser lines upwards and downwards (horizontal
laser line) and/or sideways (vertical laser line) until the
centre LED (G) lights up. Now mark the horizontal and/or
vertical reference dimension.
Adjust the sensitivity of the laser receiver with button B. Green
LED (C) for close-range working up to max. 15 m, red LED (C)
for distance-range working up to max. 50 m. The sound can
be switched on or off with button E.
AutoCross-Laser ACL 3 RX
ENGLISH 12
B A C
D E
G
F
8 9
Note:
The light intensity of the laser lines is highest in the middle and lessens
towards the edges. The maximum range of the laser receiver therefore also
changes accordingly: Green LED max. 7 – 15 m, red LED max. 30 – 50 m.