6
Innovation in Tools
GmbH & Co KG
Donnerfeld 2, D-59757 Arnsberg
Tel: 0049 2932 638-300
Fax: 0049 2932 638-333
[email protected]
www.laserliner.com
Vertical use
VERY IMPORTANT: Before using the instrument in the vertical mode, please put the AquaPro in the
horizontal position (look to “horizontal use”), but DO NOT switch it on yet. Then the compensator
clamp (4) have to set to
LOCK
before preparing instrument for vertical use.
·
Insert vertical adapter (6) for use without tripod.
·
Fit both vertical adapter (6) and tripod adapter for use on tripod.
·
Set bubble (8) by setting screw of vertical adapter (6). Please take care to set bubble very
precisely as compensator will not work in vertical mode.
·
Switch the AquaPro on, remaining functions are the same as described for horizontal use.
Infra-red remote control
The keys of the remote control are identical with the keys of the instrument with the exception of the
„POWER“-key. With the „POWER“-key of the remonte control the AquaPro can only be switched-off
but not started again.
Checking accuracy
Set up the AquaPro in rotating mode and take reading on wall at distance of 10 meters.
Mark laser line on wall. Turn instrument 180° around its vertical axis and take 2
nd
reading.
Mark centre point between two readings. Deviation of both readings fom centre point should not
exceed 2 mm per 10 meters.
Take two more readings after turning instrument 90° around its vertical axis and proceed as
mentioned above.
If the unit is disadjusted please contact Umarex-Laserliner or an authorized workshop.
Laser receiver:
1 Vial
7 Battery
box
12
Display
2
Display
8
Sound on/off
13 ¼” Mounting hole
3 Referece
rabbet
9 Fine/coarse
14 Battery installation
4
Receiving window
detection
symbol
5
On/Off switch
10 Illumination on/off
15 Zero indication line
6 Buzzer
11
Magnet
16
cm-Scale
Installation of batteries:
·
Open the battery compartment cover “7” by use of a coin.
·
Put in two 1.5 V AA batteries according to installation symbol “14” on
backside of the laser receiver (take care of correct polarity!). Close cover.
·
In order to save battery power the receiver will automatically turn off if it
has not received laser scanning signal for 5 minutes.
Universal holder with quick clamping
for levelling staff:
·
If required mount the laser receiver to clamp as per picture above.
