5
Innovation in Tools
GmbH & Co KG
Donnerfeld 2, D-59757 Arnsberg
Tel: 0049 2932 638-300
Fax: 0049 2932 638-333
[email protected]
www.laserliner.com
Operators manual AquaPro
Take special care
·
Please fully charge batteries before first use. Recharge batteries in certain intervals
if instrument is not used for longer period of time.
·
Recheck instrument in certain intervals and before important measurements.
·
Transport only in orginal protective container.
·
Clean instrument and receiver only with soft cloth.
·
Do not stare into beam.
Charging batteries
·
If lamp besides Power switch (1) is flashing batteries have to be charged.
·
Connect charger to socket (7) and power supply system.
·
Operating lamp beside socket is indicating: RED = batteries are being charged.
·
Recommended charging time: ca. 10 hours. Green light shows that you can start working with
the AquaPro, but not that batteries are fully charged.
Horizontal use
·
Put the AquaPro on a flat smooth surface or mount it on tripod head.
·
Release compensator clamp by turning wheel (4) in anti-clockwise direction until stop.
·
Press power key (1).
·
Horizontal line is set level within range of +/- 3,5 °.
·
Laser head starts rotating.
·
The „POWER“ and „SCAN“ lamps will show permanent red light.
Audible signal indicates that instrument was set up outsight of compensator range of +/- 3,5 °.
Set up instrument on more even surface.
·
Use keys
tu
(2) in order to select the desired rotating speed.
·
Use key (3)
to select two scanning modes or red dot mode.
·
Press key (3) again in order to return to rotating mode.
The lamp „SCAN“ will show red flash light when working in scanning modes or red dot mode.
In rotating mode this lamp will show permanent red light.
·
In scanning modes and red dot mode keys
tu
(2) are used to set target to any desired point.
Genauigkeitseinstellung fein / normal:
Der Laserempfänger ist mit zwei Genauigkeitsstufen ausgestattet.
·
normal: Genau 2,5 mm
·
fein: Genauigkeit ± 1.0 mm
Zur Auswahl die Taste “9” drücken.
Anzeige “2” bezeichnet die Einstellung “fein” (siehe Zeichnung)
LASERBEAM
DO NOT STARE
INTO THE BEAM!
LASER CLASS 2 M
