Ulvac DAP-9D-DC24, Инструкция по эксплуатации

Страница: 9 / 27

０４
・
Cautions for Safety in Use
Applications
(1) This pump is not designed to be explosion-proof, and should therefore not be used to
discharge explosive gases.
(2) Not be used with toxic gases. In addition to discharge of gas via the outlet, gas may also leak
from other parts of the pump, and it should therefore not be used with toxic gases. If toxic
gas is discharged for any reason it is important to note that the interior of the pump will be
contaminated by the gas, requiring appropriate caution during maintenance.
Maintenance and Repair
(3)
When requesting the manufacturer’s service division to dismantle and repair the pump,
always note the gas which the pump has been used with on the Usage Status Check Sheet.
Note that if it has been used to discharge toxic gas for any reason it will be contaminated.
Please be aware that use with some gases will preclude dismantling and repair.
Installation
(1) Do not use the pump in an explosive atmosphere. Such use may result in injury and fire.
(2) Ensure that there are no inflammable materials such as solvents in the vicinity when using
the pump.
(3) Ensure that the pump is freely ventilated to prevent overheating which may result in fire or
burns.
(4) This product is suitable for use in industrial areas. In residential areas this product may
cause radio interference in which case the user(or Installer of the final product) may be
required to take adequate measures.
Information for Electromagnetic compatibility (EMC)
Compliance standard
[Emission]
EN 61000-6-4:2007+A1:2011
[Immunity] EN 61000-6-2:2005
Power Supply
(5) Set up the overcurrent protective device(ex. Circuit breaker(3A)) for power supply. And
always turn off the overcurrent protective device before checking or repairing the pump.
Failure to do so may result in the pump suddenly starting and causing injury.
(6) Ensure that the relevant wiring is in accordance with technical standards for electrical
equipment and wiring regulations. Incorrect wiring may result in fire.
(7) Use the pump only at the rated voltage. Use at other than the rated voltage may result in the
motor burning out, or fire.
(8) Do not damage, modify, pull the lead wire, or place objects on it. Damage to the lead wire
may result in fire.
(9) Lead wire must be routed and protected so that damage to conductor insulation cannot result
from contact with any rough, sharp edge, or moving part. And lead wire must be avoided
from the mechanical stress.
(10)The power supply must use the SELV power supply or Limited Current Circuits. SELV and
Limited current circuits are defined by IEC/EN60950-1.
(11)Do not pull the lead wire to disconnect from the power source, as it may cause breakage
resulting in leakage, and fire.
(12) Do not touch the lead wire with wet hands .
! Danger
! Warning