Ultre 5400 - User Manual
4-7
Loading - 4
■
Preparing the Bulk Load Supply Cassette
(Dark Room Load) (
Ref: Figures 1-4)
1. Place the supply cassette on a table with the material exit slot facing you.
Loosen the four quarter-turn fasteners counterclockwise and lift off the cassette
lid
2. Remove the spool assembly from the supply cassette. The shaft of the spool
assembly is notched to accommodate the following media widths: 150, 200,
250, 280, *305, 310, 338, 355, 380, *400, *406 mm. On the left side of the
spool assembly is a brake mechanism and an end bell assembly. On the right
side is a spring loaded end bell assembly. As you depress the thumb release
button, remove the right side end bell from the shaft.
3. Push the thumb release button on the left end bell (next to brake) and adjust the
end bell for the desired media width
(Note special instructions for 305,400
and 406 mm media widths on page 4-4 and 4-5)
. Make slight adjustments
with the thumb release button until the end bell assembly locks into the appro-
priate notch on the shaft. (Ref:Fig.2)
4. In a totally dark room, or safe-lit room (using green safelight filters), remove
the material from its wrapping.
5. Slide the roll of film onto the spool assembly and push it up against the end
bell. Note: Push the material against the end bell with the utmost care. Ensure
that the film is flush with the end bell. Otherwise registration accuracy cannot
be guaranteed.
