www.ultravation.com
2
NOTICE:
Ultravation coil irradiation equipment is designed for installation in HVAC (heating, ventilation, and air conditioning) systems.
It is recommended a trained technician install this unit. Installation near an A/C coil will help keep the coil free of microbial
growth and eliminate odors associated with such growth. The UVMatrix
TM
SI is designed to operate constantly and should
not
cycle on and off with a blower motor. The preferred location to install the unit is on the supply side of the evaporator coil
exiting the HVAC system. Placement between 4-24 inches to the coil surface assures less untreated area as shown below:
Shipping and Packaging List:
•
2 Electrical Housing
•
2 Expandable Poles
•
4 ¼x20 Phillips head pole screws
•
UVC Warning Label
•
Warranty Card
•
Center Lamp Support
•
Appropriate Quantity of Lamps
•
Appropriate Quantity retaining nuts
•
1 Grommet per retaining nut
•
4
– “L” Brackets for optional mounting
•
8
– ¾” Self tapping mounting screws
It is recommended that this unit be installed and
maintained by a trained technician.
The UVMatrix
TM
SI Series systems are required to be
wired from a disconnect switch so the power can be
turned off for maintenance.
It is recommended that the UVMatrix
TM
SI Series systems
be wired through a safety interlock switch that will
disengage power to the equipment in the event that a
door or access panel is opened.
In the event of accidental breakage or replacement of the
ultraviolet lamp, please ensure that the lamp is disposed
of in accordance with local and state environmental laws
regarding fluorescent lamps containing mercury.
Safety Precautions:
WARNING: UV hazard. Always protect eyes from
ultraviolet light. NEVER look at UV lamps in
operation. Unplug or disconnect power
before re-lamping or servicing.
WARNING: No openings in the air handler or duct are
allowed which would give direct line-of-sight
to the UV light.
CAUTION: Equipment Damage Hazard. Ultraviolet light
can cause shift or surface degradation and
sometimes structural degradation of non-
metallic components. Select mounting
location that prevents exposure to plastic
flexible duct components, polyurethane
foam, insulation material, rubber hoses, wire
insulation, etc. If mounting options are
limited, items above should be protected with
ultraviolet resistant material such as
aluminum foil, aluminum tape, or metallic
shields.
Evaporator
Coil
Airflow
UVC
Equipment
