Ultrasonix SONIX Series, Руководство по обслуживанию

Страница: 27 / 136

3.1.5 Wiring Requirements
3.1.5.1 Main AC Connection
The electrical feed to the system should be a dedicated/isolated line (no other equipment
on the same line) with a third-wire ground. Ensure a low impedance path for current to
return to the source.
3.1.5.2 Network Connection
It is the user’s responsibility to provide an Ethernet connection to the system and to install
the correct type of cable in accordance with the building's applicable standards. The
commonly used cable is CAT5 (Category 5, 10 Base-T, unshielded twisted pair).
3.1.5.3 Image Management Network
Obtain the following information from the system administrator:
•
list of all equipment that is part of the Image Management network
•
logical diagram of the network showing topology, subnets, etc.
•
locations of all equipment
•
location of all LAN attachment points
•
locations of all power outlets and connector types
•
location of any dedicated analog phone line
•
All necessary Internet Protocol (IP) addresses and subnet information
SONIX Service Manual SSM – 001, Revision F Chapter 3: System Installation
19