USER
MANUAL
Parts & Function
Belt Clip
Wall Mount Bracket
Battery
Cover
Power Installation
Remove the screws to open the battery
cover
Insert a CR123A battery
and replace the battery
cover
Mounting on the wall
Indoor
Outdoor
o
/ 7mm
25mm
50mm
50mm
Marking the holes
using a pencil.
Drilling holes using an electric drill.
Marking the holes using a pencil.
Drilling
holes using an electric drill as above
Mount the bracket using screwdriver.
Put the rubber pads to cover the
screw.
Mount the transmitter and bracket
using screwdriver. Put the rubber
pads cover the screw.
Code Conflict
If the transmitter coding is the same as another transmitter you must change the code. When you have
changed the code re-pair the transmitter
Open the battery cover
remove the CR-123A
battery
Press and hold the call button, insert
the battery whilst holding the button
for 5 seconds. The LED will flash 5 times
when a new code is generated
Battery Low
Accessory
When the battery is battery low, The LED will blink 5 times after operation and It will send the battery low
information to the receiver together with trigger signal. The battery low information also show on the
receiver.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: Modifications to this product will void the user's authority to operate this equipment.
RoHS
2002/95/EC
C
R
-1
2
3
A
+
Call
button
LED indicator
(under the button)
Split-ring for
attaching
Lanyard
Mount Kit
Mounting Bracket
Belt Clip
Spacer
Double-sided
adhesive
For mounting PCBA to
waterproof box
Regenerate the code
Lanyard
P800-MT/2
If the transmitter is installed outdoors, to prevent it
from being easily stolen, you can install it as follows
Attach the transmitter to
the bracket together with
screw provided.
Pairing
Install the belt clip
Need to pair the transmitter & receiver before use, The pairing step please refer to the user manual of receiver
Place the belt clip on the
back side of the transmitter
Tie the screw with a coin
